P2601 BMW Fault Code

Description:

The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

P2601 Code Symptoms :

The rule of P2601 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P2601.

Likewise, overriding the OBD system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Diagnosis And Repairing P2601

P2601 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P2601 code ?

• Exhaust gas leaks
• EVAP system hose leaking
• Faulty select solenoid
• Faulty starter motor

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions.

However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.